Mounting The Cutting Unit Drive Motors - Toro 03206 Operator's Manual

Figure 18
4. Route a tipper chain up through the slot on the end
of each carrier frame. Secure the tipper chain to the
top of the carrier frame with a bolt, a washer, and a
locknut (Figure 19).
Figure 19
1. Tipper chain
11
Mounting the Cutting Unit
Drive Motors
No Parts Required
Procedure
1. Position the cutting units in front of the lift arm
pivot rods.
2. Remove the weights and gasket (Figure 20) from the
inside end of the right hand cutting unit.
1. Weights
3. Remove the plug from the bearing housing on the
outside end of the right hand cutting unit and install
the weights and gasket.
4. Locate the spider coupling (Figure 21) shipped in
the bearing housing.
1. Spider coupling
2. Reel motor
5. Remove the shipping plug from the bearing housings
on the remaining cutting units (Figure 16).
6. Insert the O-ring (supplied with the cutting unit) on
the flange of the drive motor.
7. Mount the motor and the spider coupling to the
drive end of the cutting unit, and secure it with two
capscrews provided with cutting unit.
20
Figure 20
2. Gasket
Figure 21
3. O-ring