Installing The Cutting Unit Drive Motors - Toro Reelmaster 3100-D Operator's Manual

Figure 21
1. Thrust washer
2. Carrier frame
3. Grease all the lift arm and carrier frame pivot
points.
Important:
Ensure that the hoses are free
of twists or sharp bends and that the rear
cutting unit hoses are routed as show in
(Figure 22). Raise the cutting units and
shift them to the left (Model 03171). The
rear cutting unit hoses must not contact
the traction cable bracket. Reposition the
fittings and/or hoses if necessary.
Figure 22
4. Route a tipper chain up through the slot on the
end of each carrier frame. Secure the tipper
chain to the top of the carrier frame with a bolt, a
washer, and a locknut
g012016
3. Lynch pin
g011965
(Figure 23).
1. Tipper chain
9
Installing the Cutting Unit
Drive Motors
No Parts Required
Procedure
1. Position the cutting units in front of the lift arm
pivot rods.
2. Remove the weight and O-ring
the inside end of the right cutting unit.
1. O-ring
2. Weight
21
Figure 23
(Figure
Figure 24
3. Mounting bolts
g011218
24) from
g011964