Mounting The Cutting Unit Drive Motors - Toro Reelmaster 3100-D Series Operator's Manual

3. Grease all the lift arm and carrier frame pivot
points.
Important:
Ensure that the hoses are free
of twists or sharp bends and that the rear
cutting unit hoses are routed as show in
(Figure 21). Raise the cutting units and shift
them to the left (Model 03171). The rear
cutting unit hoses must not contact traction
cable bracket. Reposition the fittings and/or
hoses, if necessary.
Figure 21
4. Route a tipper chain up through the slot on the
end of each carrier frame. Secure the tipper
chain to the top of the carrier frame with a bolt, a
washer, and a locknut
Figure 22
1. Tipper chain
g011965
(Figure 22).
g011218
12
Mounting the Cutting Unit
Drive Motors
No Parts Required
Procedure
1. Position the cutting units in front of the lift arm
pivot rods.
2. Remove the weight and O-ring
the inside end of the right cutting unit.
1. O-ring
2. Weight
3. Remove the plug from the bearing housing on
the outside end of the right cutting unit and
install the weights and gasket.
4. Remove the shipping plug from the bearing
housings on the remaining cutting units.
5. Insert the O-ring (supplied with the cutting unit)
on the flange of the drive motor
20
(Figure
Figure 23
3. Mounting bolts
(Figure
23) from
g011964
24).