YASKAWA CIMR-F7Z44P0 User Manual page 55

AUTO Reference (REF) Indicator
The status of the AUTO "Reference" (REF) indicator is shown in Table 3.4. This indicator is always "Off" when the Drive is
in the "Hand" mode. When the Drive is in the "Auto" mode, the REF indicator status is dependent on the setting of parameter
"b1-01" (Frequency Reference Selection).
Indicator Status
On
Off
Run Indicator
The status of the "RUN" indicator is shown in Table 3.5 when the Drive is in either the "Hand" or "Auto" mode.
Stop Indicator
The status of the "STOP" indicator is shown in Table 3.6 when the Drive is in either the "Hand" or "Auto" mode.
Indicator Status
Blinking
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 3.4 AUTO Reference (REF) Indicator
Hand Mode
N/A
Table 3.5 RUN Indicator
Indicator Status
On
Blinking
Off
Table 3.6 STOP Indicator
On Drive is decelerating to a stop or stopped
Drive is in a run condition but the frequency reference is zero or
Drive is running in "Auto" mode and OFF has been pressed
Off Drive is running
Digital Operator 3 - 6
Auto Mode
Parameter "b1-01" (Frequency Reference Selection) is set to terminal
strip, communications, or an option board as indicated below:
b1-01=1 (Terminals)
=2 (Communications)
=3 (Option PCB)
Parameter "b1-01" (Frequency Reference Selection) is set to digital
operator as indicated below:
b1-01=0 (Operator)
Condition
Drive is running
Drive is decelerating to a stop
Drive is stopped
Condition