Digital Operator Copy Function Faults - YASKAWA CIMR-F7Z44P0 User Manual

Digital Operator COPY Function Faults

These faults can occur occurred during the operator COPY function. Fault content is displayed on the operator. An error during
the COPY function does not activate the fault contact output or alarm output.
Function Digital Operator Display
PRE
READ IMPOSSIBLE
READ IFE
READ DATA ERROR
Function
RDE
DATA ERROR
CPE
ID UNMATCHED
VAE
INV. KVA UNMATCH
CRE
CONTROL UNMATCHED
COPY
Function
CYE
COPY ERROR
CSE
SUM CHECK ERROR
VYE
Verify
Function VERIFY ERROR
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 6.5 Digital Operator COPY Function Faults
Probable Causes
o3-01 was set to 1 to write a parameter
when the Digital Operator was
write-protected (o3-02 = 0).
The read data length does not agree.
The write data is incorrect.
An attempted write of a parameter to
EEPROM on the Digital Operator failed.
The Drive product code or software number
is different.
The capacity of the Drive being copied and
the capacity in the Digital Operator are
different.
The control method of the Drive being
copied and the control method in the
Digital Operator are different.
The parameter written to the Drive was
compared with the parameter in the Digital
Operator and they were different.
The checksum in the Drive parameter area
was compared with the checksum in the
Digital Operator parameter area and they
were different.
The set value of the digital operator and the
Drive do not match.
Diagnostic & Troubleshooting 6 - 14
Corrective Action
Set o3-02 to 1 to enable writing parameters
with the Digital Operator.
• Repeat the Read.
• Check the Digital Operator cable.
• Replace digital operator.
• A low Inverter voltage has been detected.
• Repeat the read
• Replace Digital Operator.
Use COPY function for the same product
code and software number.
Use COPY function for the same Drive
capacity.
Use the COPY function for the same con-
trol method.
COPY retest
Retry the copy.
Retry Verify function
After COPY is retested, Verify is retested