Table of Contents
Advertisement
For example:
If b5-20= 10425 then at 100% setpoint/feedback the digital operator would display 42.5 for monitor U1-38 or U1-24.
b5-21 Sleep Source
Setting
0
SFS Input (Output of PI block)
1
PI Setpoint (factory default)
2
Snooze
Parameter b5-21 selects the sleep function characteristic action:
When b5-21= "0: SFS Input" the sleep function start level (b5-15) is compared to the Drive's output (Speed Command after PI
block). This is the setting that should be used for open loop or closed loop control.
It is also possible to have the sleep function start level (b5-15) compared to the Drive input or setpoint. For this special
application set b5-21= "1: PI Setpoint".
When b5-21= "2: Snooze" a variation of the sleep function called "Snooze" is enabled, see parameter b5-22 to b5-27.
The sleep function can be used even if the PI function is disabled (b5-01= "0: Disabled").
IMPORTANT
b5-22 PI Snooze Level
Setting Range: 0 to 100%
Factory Default: 0%
b5-23 PI Snooze Delay Time
Setting Range: 0 to 3600 Seconds
Factory Default: 0 Seconds
b5-24 PI Snooze Deactivation Level
Setting Range: 0 to 100%
Factory Default: 0%
The Snooze Function is a variation on the Sleep Function. The Snooze function must be selected by setting parameter
b5-21= "2: Snooze". Once the Snooze Function is selected, the Drive monitors the output frequency. If the output frequency
drops below the PI Snooze Level (b5-22), and stays below that level for at least the PI Snooze Delay Time (b5-23), the Drive
output shuts off. This is different from the Sleep Function because it is the feedback that must drop below the PI Snooze
Deactivation Level (b5-24) before normal Drive output will begin again. See Fig 5.19 on next page.
b5-25 PI Setpoint Boost Setting
Setting Range: 0 to 100%
Factory Default: 0%
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Programming 5 - 22
Advertisement
Table of Contents
