Table of Contents
Advertisement
Shunt Connector CN15
The shunt connector CN15 is described in this section. Shunt connector along with parameters H4-07 and H4-08 select the sig-
nal range of the analog output terminals FM and AM.
Shunt connector CN15 is only available when the optional Terminal Card with the 4-20mA Analog Output Monitor is installed
(Model No. ETC618120). See Chapter 7, Maintenance, for installation of the optional Terminal Card.
The function of various shunt connector CN15 configurations is shown in Table 2.10.
CN15
The software configuration for the analog output monitor signal type is listed below:
Parameter
Parameter Name
No.
Digital Operator Display
Terminal FM Signal Level
H4-07
Selection
AO Level Select1
Terminal AM Signal Level
H4-08
Selection
AO Level Select2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Fig 2.5 Shunt Connector CN15 Location
Table 2.10 Shunt Connector CN15 Configuration Options
Analog Output Monitor Configurations
Voltage Output (0-10Vdc) for terminals FM-AC (CH1) and AM-AC (CH2)
Current Output (4-20mA) for terminals FM-AC (CH1) and AM-AC (CH2)
Voltage Output (0-10Vdc) for terminals FM-AC (CH1)
Current Output (4-20mA) for terminals AM-AC (CH2)
Current Output (4-20mA) for terminals FM-AC (CH1)
Voltage Output (0-10Vdc) for terminals AM-AC (CH2)
Description
0: 0 - 10 V
2: 4-20 mA
0: 0 - 10 V
2: 4-20 mA
Electrical Installation 2 - 16
Setting
Factory
Menu
Range
Setting
Location
0 or 2
0
Programming
0 or 2
0
Programming
Advertisement
Table of Contents
