Table of Contents
Advertisement
21. Check the signal for proper polarity. Observe if the speed command can achieve the minimum and maximum speeds
desired. If not, perform the following:
For 0-10Vdc input (Terminal A1)
1.
With no input, adjust Bias (H3-03 setting) until an output of "0.0 Hz" is obtained.
2.
With full-scale input, adjust Gain (H3-02 setting) until an output of "60.0 Hz" (or other desired maximum
frequency) is obtained.
For 4-20mA input (Terminal A2)
1. With 4mA input, adjust Bias (H3-11 setting) until an output of "0.0 Hz" is obtained.
2. With 20 mA input, adjust Gain (H3-10 setting) until an output of "60.0 Hz"
(or other desired maximum frequency) is obtained.
THIS COMPLETES THE DRIVE START UP PROCEDURE.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Start Up 4 - 9
Advertisement
Table of Contents
