Allied Telesis x950-52XTQm Installation Manual page 27

Table 6. Link and Activity Status LEDs for 40Gbps QSFP+ or 100Gbps
QSFP28 Transceivers (Continued)
State
Off
LEDs for Breakout Cables
The LED states for breakout cables are described in Table 7.
Note
For the LED states for 40Gbps QSFP+ or 100Gbps QSFP28
transceivers, see Table 6 on page 26.
Table 7. Link and Activity Status LEDs for 10Gbps Breakout Cables
State
Solid Amber At least one of the four ports on the breakout cable
has established a 10Gbps link to a network device.
Flashing Amber At least one of the four ports on the breakout cable
is sending or receiving data.
x950 Series Installation Guide for Standalone Switches
Description
Possible causes of this state are listed here:
- The transceiver slot is empty.
- The transceiver has not established a link to a
network device.
- The LEDs are turned off. To turn on the LEDs,
use the eco-friendly button in the management
panel or the NO ECOFRIENDLY LED command
in the command line interface.
Note
The x950-52XSQ and x950-52XTQm
switches do not have the eco-friendly button.
Description
27