Table of Contents
Advertisement
Caution
Use the adjustment bracket screws supplied with the inner rail.
Using screws other than those supplied may result in equipment
damage.
E62
Warning
When installing the outer and inner rails, and adjustment bracket,
ensure the components are securely attached with the appropriate
screws. If not securely attached, a serious accident may occur due
to falling equipment.
Warning
When installing and removing the switch from the rack, disconnect
the media and power cables.
Warning
A built-in stopper prevents the outer rail from extending beyond its
maximum length of 960 mm (37.8 in). Do not extend the rail by force
beyond this point, otherwise, the outer bracket will be weakened,
and the switch may fall from the rack; equipment could be damaged.
E65
Warning
Ensure the front and rear of both outer rails are attached at the same
distance from the floor, otherwise the switch may fall from the rack.
E66
Warning
Be careful to not drop the switch when lifting and not to pinch your
fingers when inserting the switch into the rack.
Warning
Other than maintenance work, secure the switch to the outer rail (via
the adjustment bracket): If the switch is not secured properly, there
is a risk of the switch falling out during movement caused by an
earthquake.
E68
x950 Series Installation Guide for Standalone Switches
E63
E64
E67
141
Advertisement
Table of Contents
