Installing Remote Control - Kemppi MasterTig 325DC Operating Manual

2.9 Installing remote control

Remote controls are optional. To enable remote operation, set the Remote control mode in the control panel settings.
For MTP23X and MTP33X control panels, refer to MTP23X/33X "Settings" on page 32 and for MTP35X control panel, refer
to MTP35X "Settings view" on page 48.
When the Remote mode is selected on the control panel, and both, wireless and wired, remotes are connected, the
wired remote will be used.
Refer to the (+) and (-) signs on the battery holder and in the remote for the correct positioning of batteries.
Tools:
• Screwdriver, Torx head (T15).
Wireless hand remote control (HR45)
1. Take the remote control battery holder out. Install the batteries (3 x AAA) and put the holder back into the remote.
© Kemppi
MasterTig 235ACDC, 325DC, 335ACDC, 425DC
18
Operating manual - EN
1920900 / 2215