Kemppi MasterTig 325DC Operating Manual page 31

Parameter
Hot start level
Hot start time
Minilog
Downslope
Post gas
Adjustable parameters in spot welding:
Parameter
Pre gas
Upslope
Downslope
Post gas
Adjustable parameters in MicroTack welding:
Parameter
Pre gas
Post gas
Adjustable parameters in AC mode:
Parameter
Balance
AC Frequency
Adjustable parameters in Pulse mode:
Parameter
Pulse current
Pulse ratio
Base current
Pulse frequency
© Kemppi
Value
Min/Max = -80 % ... +100 %, 1 % step
(Default = Off), Value '0' = Hot start off
Min/Max = 0.1 s ... 9.9 s, 0.1 s step (Default
= 1.2 s)
Min/Max = -99 % ... +125 %, 1 % step
(Default = Off), Value '0' = Minilog off
Min/Max = 0.0 s ... 15.0 s, 0.1 s step
(Default = 0.1 s)
Min/Max = 0.0 s ... 30.0 s, Auto, 0.1 s step
(Default = Auto)
Value
Min/Max = 0.0 s ... 9.9 s, Auto, 0.1 s step
(Default = Auto)
Min/Max = 0.0 s ... 5.0 s, 0.1 s step (Default
= 0.0 s)
Min/Max = 0.0 s ... 15.0 s, 0.1 s step
(Default = 0.1 s)
Min/Max = 0.0 s ... 30.0 s, Auto, 0.1 s step
(Default = Auto)
Value
Min/Max = 0.0 s ... 9.9 s, Auto, 0.1 s step
(Default = Auto)
Min/Max = 0.0 s ... 30.0 s, Auto, 0.1 s step
(Default = Auto)
Value
-60 % ... 0 % (Default = -25%)
30 Hz ... 250 Hz (Default = 60 Hz)
Value
2 A ... Power source max A, 1 A step *
10 % ... 70 %, 1 % step (Default = 40 %) *
10 % ... 70 %, 1 % step (Default = 20 %),
amperes visible *
(DC): 0.2 Hz ... 300 Hz, 1 Hz step (0.2 Hz ...
10 Hz step is 0.1 Hz) (Default = 1 Hz) *
31
MasterTig 235ACDC, 325DC, 335ACDC, 425DC
Operating manual - EN
Note
This adjustment is not available when
Hot start is off.
Hot start time cannot be adjusted when
4T trigger logic is selected.
This adjustment is not available when the
2T trigger logic is selected.
Note
This adjustment is not available when the
Lift TIG ignition is turned on.
Note
This adjustment is not available when the
Lift TIG ignition is turned on.
Note
Note
1920900 / 2215