Installing Remote Control (Optional) - Kemppi MasterMig 353 Operating Manual

2.6 Installing remote control (optional)

Remote controls are optional. To enable remote operation, connect the remote control device to the MasterMig welding
equipment. The remote control mode can be set and adjusted in the control panel settings ("Control panel: System set-
tings" on page 42).
Remote control HR43/HR40
1. Connect the remote control cable to the control cable connector.
2. Adjust the remote control parameters in the control panel settings.
© Kemppi
19
MasterMig 353, 355
Operating manual- EN
1921960 / 2217