Kemppi MasterTig 325DC Operating Manual page 50

Parameter
Ignition current
Negative ignition time
Ignition time
Slight upslope
Startup level
Downslope cut level
2T downslope cut
Nonlinear downslope
Current freezing
TIG antifreeze
AC phase swap current
MMA settings:
Parameter
Welding current
Hot start
Arc force
MMA antifreeze
VRD mode
System settings:
Parameter
Gas test
Water cooler
Cooler flow watch
Brightness
Weld data time
Show Weld Assist
Screen saver
© Kemppi
Value
(DC): 100 % ... 300 % / Auto, step 1 %
(Default = Auto)
(ACDC): 0 ms ... 950 ms / Auto, step 10 ms
(Default = Auto)
(DC): 0 ms ... 950 ms / Auto, step 10 ms
(Default = Auto)
OFF / ON (Default = OFF)
5 % ... 40 %, step 1 % (Default = 10 %)
5 % ... 40 %, step 1 % (Default = 10 %)
OFF / ON (Default = OFF)
0 % ... 50 %, step 1 % (Default = 0 %)
OFF / ON (Default = OFF)
OFF / ON (Default = OFF)
5 A ... 20 A / Auto
Value
Min/Max = Normal welding current limits
-10 ... +10, step 1 (Default = 0)
-10 ... +10, step 1 (Default = 0)
OFF / ON (Default = OFF)
OFF / ON (Default = OFF)
Value
Gas test time: 0 s ... 60 s, step 1 s (Default
= 20 s)
OFF / Auto / ON (Default = Auto)
OFF / ON (Default = ON)
10 % ... 100 %, step 1 % (Default = 100 %)
1 s ... 10 s, step 1 s (Default = 5 s)
ON / OFF (Default = ON)
Default = Kemppi logo
50
MasterTig 235ACDC, 325DC, 335ACDC, 425DC
Operating manual - EN
Note
Note
This setting can be locked so that the
user cannot change it. In the equipment
models where the VRD mode is locked
permanently to ON (e.g. AU model), the
VRD option is still visible in the settings,
but it cannot be changed.
Note
Activating this starts the gas test with
default time. Time can be changed by
turning the control knob. Gas test can be
stopped by pressing the control knob
again.
An alternative screen saver image can be
used. For more information, refer to
"Screen saver" on page 53.
1920900 / 2215