2.8 Installing remote control
Remote controls are optional. To enable remote operation, set the Remote control mode in the control panel set-
tings (refer to "Settings view" on page 29).
When the Remote mode is selected on the control panel, and both wireless and wired remotes are connected, the wired
remote will be used.
Refer to the (+) and (-) signs on the battery holder and in the remote for the correct positioning of batteries.
Tools:
•
Screwdriver, Torx head (T15).
Wireless hand remote control (HR45)
1.
Take the remote control battery holder out. Install the batteries (3 x AAA) and put the holder back into the
remote.
© Kemppi
15
Master 315
Operating manual - EN
1921530 / 2052