To set the wedge center position
When Wedge is selected in the <Mode> group, you can set the wedge center
position.
1
2
Split settings
You can set the degree to which the image is split, the split positions, and other
parameters.
To apply the Split effect
With the Split menu displayed, use the following procedure.
1
676
DME Special Effect Operations
• When Bar was selected in step 1
Knob
Parameter
Adjustment
1
Width
Width of partition
2
Offset
Degree of randomness in partition
width
3
Angle
Starting angle of effect
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
• When Wedge was selected in step 1
Knob
Parameter
Adjustment
4
No
Width of blocks
5
Phase
Partition position
Press [Position].
Set the following parameters.
Knob
Parameter
Adjustment
1
H
Horizontal center position
2
V
Vertical center position
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
In the <Mode> group, select the split method.
Single: Leave gaps between splits.
Double: Fill gaps between splits with the same image.
Setting values
0.000 to 100.000
a)
–5.000 to +5.000
b)
–20.000 to 20.000
–8.000 to +8.000
Setting values
0.000 to 100.000
–8.000 to +8.000
Setting values
a)
–8.000 to +8.000
b)
–32.000 to +32.000
a)
–6.000 to +6.000
b)
–18.000 to +18.000