Sony MVS-8000 User Manual page 412

Hide thumbs Also See for MVS-8000:

Table of Contents

To specify the playback start point

To make the current position the playback start point, press the [START TC]

button. To set a different position, press the [SET START TC] button, then

enter the timecode from the numeric keypad control block.

To specify the duration

Press the [SET DUR] button, and enter a timecode from the numeric keypad

control block. If the playback start point is already set, this automatically sets

the playback stop point. If the playback stop point is already set, this

automatically sets the playback start point. (The duration setting is not

displayed in the device control block.)

To specify the playback stop point

Start playback, and at the desired position press the [STOP] button to stop

playback, then press the [STOP TC] button. To set to any position, press the

[SET STOP TC] button, and enter a timecode from the numeric keypad control

To carry out the variable speed playback

Use the search dial.

For details on using the search dial, see "Controlling the Tape/Disk

Transport" in Chapter 12 (Volume 2).

To apply a loop to a frame memory clip

Press the [LOOP] button.

Using the device control block (trackball) or device control block

(joystick) to play back clips

A frame memory clip must first be recalled with a menu operation.

For details of the buttons in the device control block (trackball) or device

control block (joystick), see "Device Control Block (Trackball)" (page 74) in

Frame Memory Clip Operations

Press the [DEV] button in the region selection buttons, and select the frame

memory clip for playback (FM1 CLIP to FM8 CLIP).

If the pair mode is on, both main and subsidiary FMs light.

Press the [PLAY] button, turning it on.

To stop playback, press [STOP] or any of the [SHTL], [JOG], [CUE],

[REW], [FF], and [ALL STOP] buttons.