Sony MVS-8000 User Manual page 1163

3
If in step 1 you selected a value in the range 1 to 64, turn the knob to select
the source table.
Knob
3
4
Press [Source Table Set] to confirm the selection.
5
Repeat steps 1 to 4 as required.
To set the shift operation of the destination selection buttons
To set the operation mode of the rightmost button in the destination selection
button row, select one of the following in the <Dest Shift Mode> group of the
Panel >Aux Assign >RTR Mode Setting menu.
Hold: Acts as a shift button, and the shifted destination selection buttons are
enabled while the button is held down.
Lock: Acts as a shift button, and pressing the button toggles between the
shifted and unshifted states of the destination selection buttons.
Off: Acts as a destination selection button, that is, button number 16 on a 16-
button system, button number 24 on a 24-button system, and button
number 32 on a 32-button system.
Setting the source table
1
In the Panel >Aux Assign >RTR Mode Setting menu, press [Source Table
Assign].
The Source Table Assign menu appears.
2
In the <Source Table Select> group, select the source table you want to
manipulate.
3
Press [Table Assign].
The Table Assign menu appears.
The left of the status area lists the button numbers and set sources, and the
right side lists the source that can be assigned.
4
Using any of the following methods, select a source selection button and
the source you want to assign.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Parameter Adjustment
Source Source table selection
Table
Auxiliary Bus Control Block Settings (Aux Assign Menu)
Setting values
1 to 5
1163