Sony MVS-8000 User Manual page 493

Background configuration: Consists of the following combinations.
• For main: Clean, Bkgd A, Bkgd B
• For sub: Sub Clean, Utility 2, Utility 3
Key configuration: Key1 can be set to "Enable" only when the background is
Clean, Bkgd A, or Bkgd B.
For details, see "Setting the Operation Mode" in Chapter 20 (Volume 3).
To set the key preview configuration
Use the Engineering Setup >Switcher >Config >K-PVW Config menu.
The following are the differences from standard mode.
Background configuration: Clean or Sub Clean
Key configuration: Key1 can be set to "On" or "Link" only when the
background is Clean.
For details, see "Setting the Operation Mode" in Chapter 20 (Volume 3).
To assign sub outputs to output ports
Use the Engineering Setup >Switcher >Output >Output Assign menu.
You can assign a sub output signal to a switcher output port number.
For details, see "Assigning Output Signals" in Chapter 20 (Volume 3).
Assigning main and/or sub to switcher banks
For each switcher bank for which Multi Program 2 mode is selected, set
whether this is main dedicated, sub dedicated, or main and sub shared.
To assign main and sub to a single switcher bank
1
In the Engineering Setup >Panel >Config >MP2 Main/Sub Assign menu,
select the switcher bank.
2
In the <Main/Sub Assign> group, select [Main&Sub].
Main: use for main operations.
Sub: use for sub operations.
Main&Sub: use for both main and sub operations.
When "Main&Sub" is selected, it is necessary to assign [MAIN] and
[SUB] delegation buttons to the control panel.
To assign main and sub to two consecutive switcher banks
For example, to assign the first row (first switcher bank) to M/E-1 main, and
the second row (second switcher bank) to M/E-1 sub, use the following
procedure.
493
Multi Program 2