Sony MVS-8000 User Manual page 669

Ripple settings
There are four modes: Radial, Angular, Both, and Shape. The direction of
modulation differs depending on the mode. You can set the size and frequency
of the ripples, their direction and speed, their center point, and other
parameters. In Shape mode, you can select ripple shapes other than circles
(stars, etc.).
To apply the Ripple effect
With the Ripple menu displayed, use the following procedure.
1
In the <Mode> group, select the ripple modulation mode.
Radial: Points on radii of the same length from the center of the ripples
behave in the same way.
Angular: Points at the same angle from the center of the ripples behave in
the same way.
Both: Both Radial and Angular ripples are applied.
Shape: The ripples can have shapes such as stars or hearts in addition to
circles.
2
Set the following parameters, depending on the selected modulation mode.
• When Radial mode is selected
Knob
1
2
3
4
5
Modulation along radii
(Radial mode)
Modulation modes and directions
Parameter Adjustment
Amp R Ripple amplitude along radius
Freq R Ripple frequency along radius
a) Direction along radius in which
Offset R
to offset ripple phase and
amount of movement
b) Ripple direction along radius
Speed R
and speed
Amp A Ripple amplitude along
periphery
Modulation along periphery
(Angular mode)
Setting values
0.00 to 100.00
0.00 to 100.00
–8.000 to +8.000
–32.000 to +32.000
–100.00 to +100.00
0.00 to 100.00
DME Special Effect Operations
c)
d)
669