Sony MVS-8000 User Manual page 918

5
6
7
8
9
10
11
12
13
918
Shotbox Register Creation
This changes the Multifunction Flexi Pad control block to shotbox editing
mode.
Press the [STOR] button, turning it on.
The [SNAPSHOT] button lights green.
If not lighted, press the [SNAPSHOT] button to turn it on.
Notes
In shotbox editing mode, when you press the [STOR] button, the
[SNAPSHOT] button or [EFF] button lights, to indicate that snapshot data
will be saved in the shotbox register, or that effect data will be saved.
Specify the region for the snapshot to be saved, with the region selection
buttons.
Enter the number of the shotbox register where you want to save with the
memory recall section numeric keypad buttons.
To select an empty register, press the [ . ] button without entering a
number.
The number of the selected register appears in the alphanumeric display.
An "E" after the number indicates an empty register.
Press [ENTR].
This saves the region you turned on in step 6, and the register number you
recalled for that region as a snapshot setting in a shotbox register, and the
[STORE] button goes off. At the same time, the [RCALL] button lights.
Press the [EFF] button, turning it on.
Specify the register numbers to recall the keyframe effects for each region
that you want to save in the shotbox register.
For the procedure for recalling keyframe effects, see "Recalling a register
from the Multifunction Flexi Pad control block" (page 821).
Referring to steps 3 to 6, carry out the procedure to save the recalled
keyframe effect data.
In step 5, however, press the [EFF] button instead of [SNAPSHOT]
button, lighting it on.
Enter the shotbox register number specified in step 7 using the numeric
keypad buttons in the memory recall section.
Press the [ENTR] button.