Dme Wipe Pattern Variation And Modifiers - Sony MVS-8000 User Manual

Hide thumbs Also See for MVS-8000:

Table of Contents

Signals forming part of the background for a DME wipe

For a two-channel mode page turn, page roll, brick, frame in-out, and so on, the

part of the pattern shown in gray (see page 522) is filled with the signal selected

on the DME external video bus.

For three-channel mode brick, the part of the pattern shown in dark gray is

filled with the DME external video signal, and the light gray portion with the

signal selected as follows.

For a DME dedicated interface

When the DME channel used is 3 or 4, the signal selected on the DME utility

1 bus. For channel 7 or 8, the signal selected on the DME utility 2 bus.

For an MVE-8000A or MVE-9000 SDI interface

Signal selected on the AUX bus assigned in the Engineering Setup >Switcher

>Device Interface >DME Type Setting >DME SDI interface menu. (The AUX

bus is determined by which DME channel is being used.)

For the SDI interface on the MVE-8000A or MVE-9000, in some cases the

AUX bus is used in place of the DME external bus.

For details, see "Interfacing With External Devices (Device Interface Menu)"

in Chapter 19 (Volume 3).

DME Wipe Pattern Variation and Modifiers

You can modify the selected DME wipe pattern in the same way as an ordinary

wipe pattern, as follows.

For the setting operations, see "Setting DME Wipe Modifiers" (page 349).

Direction: You can set the DME wipe direction to normal, reverse, or

Edge: You can apply a border or soft border (see page 350).

alternating normal/reverse (see page 349), except for a key transition,

which is always in normal/reverse mode. However, a key transition can

only be specified when the following patterns are selected, and when other

patterns are selected, this is fixed, as normal/reverse.

Patterns: 1204, 1207, 1221 to 1224

In the case of those user programmable DME patterns for keys in which an

edge has already been applied to the effect, the behavior is as follows.

• When the DME wipe edge setting is on, only part of the edge applied in

the effect is enabled, and that portion can be adjusted (page 350).

• When the DME wipe edge setting is off, the edge applied in the effect is

enabled as is.