Sony MVS-8000 User Manual page 299

Soft border: You can adjust the border width, and the softness of the inner and
outer edges of the border.
When a border or soft border is selected, the signal filling the border is called
edge fill. For the edge fill, you can use a matte generated by the dedicated color
matte generator, or the signal selected on the utility 2 bus. A matte can include
color 1 and color 2, and a combination of the two colors (a "color mix").
1
In the M/E-1 >Wipe menu, select HF4 'Edge/Direction.'
The Edge/Direction menu appears.
2
In the <Edge> group, select the edge type.
Border: border
Soft: soft edge
Soft Border: soft border
3
Set the parameters according to the selection in step 2.
• When border is selected
Knob Parameter
1 Width
• When soft edge is selected
Knob Parameter
1 Soft
• When soft border is selected
Knob Parameter
1 Width
2 Inner Soft
3 Outer Soft
4
When you selected border or soft border, select the edge fill signal in the
<Edge Fill> group.
Utility 2 Bus: signal selected on the utility 2 bus
Matte: signal from the dedicated color matte generator
5
Depending on the operation in step 4, carry out the following operation.
When 'Utility 2 Bus' is selected: Hold down the [UTIL] button in the
cross-point control block, and select the signal on the background B
bus.
Adjustment
Border width
Adjustment
Edge softness
Adjustment
Border width
Border inner softness
Border outer softness
Basic Procedure for Wipe Settings
Setting values
0.00 to 100.00
Setting values
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
299