Coordinate Systems; Machine Functions - HEIDENHAIN ND 7000 Operating Instructions Manual

Information for the Operator | Programming (software option)
Positioning block type
Parameter
4.2.2

Coordinate systems

To change a coordinate system, you can call presets from the preset table. The
coordinate system of the selected preset will then be used after the call.
Further information: "Defining presets", Page 222
Preset block type
Parameter
Preset number
4.2.3

Machine functions

You can call machine functions to machine the workpiece.
The available functions depend on the configuration of the connected machine tool.
The following blocks and parameters are available:
Block type
Spindle speed
Tool call
M function
Dwell time
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Description
Incremental position value, i.e. the position value is refer-
enced to the actual position
Through-hole drilling without a specified position value
Description
ID from the preset table
Optional: Selection from preset table
Parameter / Description
Rotational speed of the tool spindle
Number of the tool
Optional: Selection from tool table
Further information: "Selecting a tool", Page 227
When a tool call is run, the spindle is automatically
stopped and the user is requested to load the corre-
sponding tool.
Number of the M function
Optional: Selection from function table
Time interval between machining steps
III
251