Overview - HEIDENHAIN ND 7000 Operating Instructions Manual

III
5.1

Overview

This chapter describes the production of an example workpiece. As you produce
the example workpiece, this chapter leads you step by step through the product's
operating modes based on various machining scenarios. The following machining
steps are necessary for successful machining of the flange:
Machining step
Determine preset
Machine a through hole
Machine a fit
Machine a bolt hole circle
Machine a row of holes
Figure 69: Example workpiece
262
This chapter does not describe the processing of the outside contour of
the example workpiece. It is assumed that the outside contour has already
been machined.
For a detailed description of the individual activities, please refer to the
chapters "Manual operation", "MDI mode", "Programming (software option)"
and "Program run (software option)".
Make sure that you have read and understood the "Basic Operation"
chapter before carrying out the actions described below.
Further information: "Basic Operation", Page 18
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Information for the Operator | Application example
Mode of operation
Manual operation
Manual operation
MDI mode
MDI mode
Programming and program run
(software option)