Defining The Fit; Reaming The Fit - HEIDENHAIN ND 7000 Operating Instructions Manual

III
Calling up
5.6.1

Defining the fit

5.6.2

Reaming the fit

268
Tap MDI in the main menu
The operating element can belong to a group (based
on the configuration).
Further information: "Selecting grouped operating
elements", Page 29
The user interface for MDI mode is displayed.
Tap Tools on the status bar
The Tools dialog box appears.
Tap Reamer
Tap Confirm
The associated tool parameters are applied automatically.
The Tools dialog is closed.
Tap Create on the status bar
A new block is displayed.
In the Block type drop-down list, select the Hole block type
Enter the following parameters according to the dimensional
data:
X coordinate: 95
Y coordinate: 50
Z coordinate: drill through
Confirm each entry with RET
To run the block, tap END
The positioning aid is displayed.
If the simulation window is active, the position and traverse
path are visualized.
On the machine, insert the Ø 20 mm H6 reamer into the
spindle
On the product, set a spindle speed of 250 rpm
Start the machining process—follow the instructions of the
wizard
Tap Close
Program run is terminated.
The wizard closes.
You have successfully machined the fit.
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Information for the Operator | Application example