Running The Program; Proceeding To A Specific Program Block; Aborting Program Run - HEIDENHAIN ND 7000 Operating Instructions Manual

Information for the Operator | Program run (software option)
3.2.1

Running the program

M functions are either executed automatically during program run or must
be explicitly acknowledged. You can configure the respective M function
correspondingly in the settings.
Further information: "Configuring M functions", Page 138
In Single block mode
3.2.2

Proceeding to a specific program block

To go to a specific block, you can skip blocks one by one within a program until you
reach the desired block. It is not possible to jump back in the program.
3.2.3

Aborting program run

If errors or problems occur, you can abort the execution of a program. The tool
position and the spindle speed remain unchanged when the program run is aborted.
The program run cannot be aborted if the current block is executing a
traverse motion.
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Tap NC START on the program control
The product selects the first block of the program.
Tap NC START on the program control once again
User intervention may be required, depending on the block.
The wizard shows the appropriate instruction.
With a tool call, for example, the spindle is automatically
stopped and you are requested to change the corresponding
tool.
With multi-step blocks, such as machining patterns, tap Next
to proceed to the next step in the wizard
Follow the wizard's instructions for the block
Blocks that do not require any action by the user
(such as presetting) are executed automatically.
Tap NC START to execute the next block, and continue in this
manner until the end of the program
Tap Single block on the program control to activate Single
Block mode
When the Single Block mode is active, the program stops after
each block of the program control (this also includes blocks
that do not require any action by the user).
Tap Next program step on the program control
The next block is selected.
Tap Stop program in the program management
The program run is aborted.
III
243