Simulating Program Run; Machining A Row Of Holes (Program Run) - HEIDENHAIN ND 7000 Operating Instructions Manual

Information for the Operator | Application example
5.8.4

Simulating program run

After you have successfully programmed the row of holes, you can simulate how the
program will run using the simulation window.
Figure 76: Example workpiece: simulation window
5.9

Machining a row of holes (program run)

You have defined the individual machining steps for the row of holes in a program.
You can execute the created program in Program run.
Figure 77: Example workpiece – drilling a row of holes
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Tap Simulation window
The simulation window is displayed.
Tap each program block, one after the other
The tapped machining step is shown in color in the simulation
window.
Check the view for programming errors, e.g. tool path
intersections of holes
If there are no programming errors you can machine the row
of holes.
III
273