Setting A Position As A Preset - HEIDENHAIN ND 7000 Operating Instructions Manual

III
1.3.3

Setting a position as a preset

For simple machining operations, you can use the current position as a preset and
perform simple position calculations.
Prerequisite:
A workpiece is clamped on the machine tool
The axes are referenced
Setting the current position as preset
Z
Defining the position values of the current position
Z
226
To apply the current alignment to the selected preset, activate
the Apply alignment setting with the ON/OFF slide switch
(default setting)
Tap Confirm in the wizard
The new coordinates are applied as the preset.
In a system with reference marks, zeroing and presetting are only possible
after a reference run has been performed.
After a restart of the device, it would not be possible to determine the
position of the presets without such a reference. In addition, the preset
table would lose its validity without referencing, since it would not be
possible to approach the stored points correctly.
Further information: "Conducting the reference mark search", Page 221
Approach the desired position
Long-press the axis key
The active preset in the preset table is overwritten with the
current position.
The active preset is applied as the new value.
Perform the desired machining operation
Approach the desired position
In the working space, tap the axis key or the position value
Enter the desired position value
Confirm the entry with RET
The position value is applied to the current position.
The entered position value is linked with the current position
and overwrites the active preset in the preset table.
The active preset is applied as the new value.
Perform the desired machining operation
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Information for the Operator | Manual operation