Machining Pattern - HEIDENHAIN ND 7000 Operating Instructions Manual

III
4.2.4

Machining pattern

You can define various machining patterns to machine complex shapes. From the
data you enter, the product calculates the geometry of the machining patterns and
optionally displays them in the simulation window.
The machining patterns are applicable only if the Z axis is perpendicular. If the tool
axis is not perpendicular, then the values defined in the machining patterns do not
apply anymore.
Hole block
Z
Figure 64: Schematic depiction of the Hole block
Parameter
X
Y
Depth
252
Before defining a machining pattern, you must
Define a suitable tool in the tool table
Select the tool on the status bar
Further information: "Creating a tool table", Page 156
Actual position
Applies the current axis position or current spindle
speed to the input fields of the various block types
Description
Center point of the hole in the X plane
Center point of the hole in the Y plane
Target depth for drilling in the Z plane
Default: Through-hole drilling
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Information for the Operator | Programming (software option)