Probing Or Touching Off Of Presets - HEIDENHAIN ND 7000 Operating Instructions Manual

Information for the Operator | Manual operation
1.3.2

Probing or touching off of presets

HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Tap Manual operation in the main menu
The user interface for Manual operation appears.
Tap Auxiliary functions in the status bar
In the dialog box, tap the desired function under Probing (e.g.,
Probe edge)
Select the inserted tool in the Select the tool dialog box:
When using a KT 130 edge finder from HEIDENHAIN:
Activate Using touch-probes
When using a tool:
Deactivate Using touch-probes
Enter the desired value in the Tool diameter input field
or
Select the corresponding tool from the tool table
Tap Confirm in the wizard
Follow the instructions in the wizard
Keep in mind when probing:
If applicable, specify the direction of traverse of the axis in
the dialog box
Move the edge finder toward the workpiece edge until the
red LED on the edge finder lights up
or
Move the tool until it touches the workpiece edge
Confirm each step in the wizard
Retract the edge finder or tool after the last probing
operation
The Select preset dialog appears after the last probing
procedure.
Select the desired preset in the Selected preset input field:
To overwrite an existing preset, select an entry from the
preset table
To add a new preset, enter a number that has not yet been
assigned in the preset table
Confirm the entry with RET
Enter the desired value in the Set position values input field:
Leave the input field empty to load the measured value
To define a new value, enter the desired value
Confirm the entry with RET
For the probing functions Edge probing,
Determining the center line and Determining the
circle center, you can apply the current alignment to
the selected preset. If the Apply alignment setting
is activated, then the product stores the parameter
in the preset table at completion of the probing
operation.
III
225