Table of Contents
Advertisement
„ It is advised not to store important information on USB storage devices used with the receiver. Always
make backups of data on your USB storage device before using it with this receiver. STRONG will not take
responsibility for any loss of information or circumstances caused by loss of information.
„ For a proper performance with this receiver your USB device must be formatted to FAT32.
„ STRONG cannot guarantee the playback of all les although extensions are listed, as it depends on the
used le size, codec, bit rate and resolution.
2. YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
1. Indicator LED
2. IR Sensor
2.3 Side Panel
USB:
To connect your USB storage device for multimedia functions or software update.
2.4 Rear Panel
SAT IN
Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation.
1. SAT IN
To connect to the LNB of your satellite antenna for reception of satellite broadcast
signal.
GREEN indicates that the receiver is currently ON, RED indicates that the receiver is
currently in Standby mode.
Receives the RCU commands.
2
3
4
5
6
1
2
6
7
Fig. 1
Fig.2
Fig. 3
Advertisement
Table of Contents
