Table of Contents
Advertisement
6.6 Changing the video settings
Press the OPT button in viewing mode to change settings like HDMI Resolution, Aspect Ratio and Aspect
Conversion or to have a look on the current settings. To select use pq and to change use tu. After all
settings have been made, press to quit.
NOTE:
If you select an HDMI resolution which isn't supported by your TV, the receiver will
automatically switch to the previous settings after ~10 sec. If you can see the displayed
message, please con rm the selected resolution by pressing OK.
6.7 EPG (Electronic Programme Guide)
The Electronic Programme Guide (EPG) provides an information overview on the current television
programme. The information is provided by the respective broadcaster and may not be available for all
channels.
Therein you will nd programmes information and overviews and you can also programme a timer (for
viewing or with your VCR).
To open, press the EPG button in TV mode. By default, the Grid EPG is set, which gives you a better overview
of the current programme on several di erent channels. On the left you will see the channel list, on the right
the events preview with the event information for the next hours. The corresponding short information
about the selected event is displayed in the upper right of the screen with the start and end of the event.
Use the pq buttons to select the desired channel, then press OK to switch to the channel and load its
information. If you press OK again on you will directly switch to TV mode. Use u to highlight a particular
event of the selected channel. Press INFO to display detailed information and press to close it again. Press
the BLUE button to go 6 hours forwards and press the YELLOW button to go 6h backwards (not further than
to current time). To go directly to the current time use the GREEN button. The RED button allows you to
book a timer for a selected event and with LIST you can open the timer list.
For details on editing timers, see chapter 7.3.4 Timer, the function is identical.
Use the EPG button to switch to Single EPG.
Single EPG
In this form of the EPG, you always see the list of information for the selected channel on the right where
you can use pq to select an event. The corresponding event description is located in the lower area. To
go to the next or previous day, use the BLUE and YELLOW buttons, to return to the current contents use
the GREEN button. The remaining functions stay as described above. To switch to the Grid EPG use the EPG
button and to leave the menu use or press OK for a 2nd time on the selected channel.
NOTE:
Availability of EPG data depends on broadcast and can be displayed for up to 7 days. If you are
opening the EPG just after the receiver was switched on or you change to another transponder,
we recommend to wait for a short moment in order to collect the data.
7. MAIN MENU
Press MENU in viewing mode to display the main menu. All important settings and features of your
receiver can be operated from there. It consists of the following sub-menus: Installation, Channels, Settings,
Multimedia, Update, CA Menu and Network
Use tu to select a sub-menu and pq to choose an option. Press OK to open the chosen submenu.
7.1 Installation
Press MENU and select Installation with tu. The following sub-menus are available: Antenna Setup, Motor
Setting, Channel Search and Factory Reset.
16
Advertisement
Table of Contents
