Table of Contents
Advertisement
MENU
Represents a button on the remote control or the receiver.
(Bold characters)
Move to
Represents a menu item within a window.
(Italic characters)
1.4 Accessories
Installation Instructions
„
„
1 remote control unit
„
„
2x batteries (AAA type)
„
„
WARNING:
The batteries should not be recharged, disassembled, electrically short-circuited, be mixed
or used with other types of batteries. If rechargeable accumulators instead of batteries are
going to be used (e.g. NiMH), we recommend using types with low self-discharge to ensure
long time operation of your remote control.
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible to USB 2.0
„
„
specifications, recording, playback and other multimedia functions of the receiver might not work properly. *
To ensure best performance of your USB storage device please format it via your receiver (through the menu
„
„
"Media") to FAT32 system. Other file systems are not supported by the receiver. However, it is possible to use
already NTFS formatted disks.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„
„
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power specifications may
„
„
exceed the supported output of your receiver (max. 5 V/800 mA). If so, please connect your USB HDD to an
according external power adapter.
It is advised not to store important information on USB storage devices used with the receiver. Always make
„
„
backups of data on your USB storage device before using it with this receiver. STRONG will not take responsibility
for any loss of information or circumstances caused by loss of information.
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 1234
2.2 Front Panel
1. IR sensor
2. Display
3. Mode indicator
4. USB
2.3 Rear Panel
1. CABLE IN
2. CABLE OUT
4
Point your remote control towards this sensor.
Indicates current time in STANDBY mode or current channel number in OPERATING
mode
RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode.
Connector for USB storage devices.
Connect your receiver to the wall connector provided by the cable operator
Connect your receiver to another digital receiver or to a TV to keep using its internal
(analogue) tuner (loop through function)
Fig. 1
Fig. 2
Advertisement
Table of Contents
