Your Receiver; Pin Code Default: 0000; Front And Side Panel; Rear Panel - Strong SRT 7010 User Manual

*This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via USB has
not yet been installed.

2.0 YOUR RECEIVER

2.1 PIN code default: 0000

2.2 Front and side panel

1. Remote control sensor:
2. LED display:
3. Standby indicator: Shows power state of the receiver: Red LED - receiver is in
4. Power button:
5. CH-/CH+:
6. VOL-/VOL+

2.3 Rear panel

1. SAT IN
2. Ethernet
3. USB
4. HDMI
5. TV SCART
6. Audio L/R
7. S/PDIF coaxial
8. Power connector The receiver requires a wall adapter, mains voltage input

2.4 Remote Control

1. q
2. !
3. 0-9
4. TV/R
5. 
6. FAV
7. 9
Receives the signal from the remote control
Shows channel number in operation and time in Standby
standby mode
Switch the receiver to Standby or On.
To change channels without using the remote control
Decrease/Increase audio volume. VOL-/VOL+ and CH+/CH-
double as navigation buttons when
To connect to the LNB of your satellite dish for reception of
satellite broadcast signal
To connect to a network switch, router or modem
For connection of USB device for Multimedia use
To connect to the HDMI input of your TV using a good quality
HDMI cable
To connect to TV using a SCART cable
To connect to an analogue amplifier for stereo audio
To connect to a digital or home cinema audio amplifier
100~240V AC 50~60Hz 12V, 1.5A DC output. Please check the
local power conditions before connecting the receiver to the
mains supply.
Turns the receiver ON/Standby
To turn the sound on or off
Channel number and numeric value input
Toggles between TV and radio mode
No function
To access your favourite channels. Toggles between available
favourite groups
To switch between the last viewed channels
Fig. 1
Fig. 2
Fig. 3
5