Table of Contents
Advertisement
Save / Recalculation
Go to position
USALS selection
Con gure the motor position by using the USALS function. Enter your geographic location. The motor is
able to calculate all available satellite positions, preconditioned this function is also supported by the motor.
Use pq to select the Antenna Position sub-menu.
Antenna position:
Go to position
NOTE:
7.1.3 Channel Search
In this menu, you can perform an automatic, network or transponder search. You can also search for
channels on all installed satellites. Use the pq buttons to highlight the desired item and use tu to
change the settings.
Satellite:
Transponder:
Channel type
Scan mode
Search for
One Satellite:
Selected Satellites:
NIT Table:
simpliTV List:
With Save and Recalculate, you can set whether the position should be saved or a
new calculation should be made after setting this position.
Press OK to move the motor to the centre position. This is only necessary for the rst
time to set the antenna correctly. Then you can also select a number of a position you
already have stored or check the antenna position.
Press OK to open the submenu. Use the 0~9 buttons to enter the degree of
longitude. Next, select East or West, then 0~9 to enter the latitude. Finally, specify
North or South. Finally, select Save and press OK to con rm your entries.
Press OK to move the motor to the desired satellite position. After computation, you
can also select other satellites, go to Satellite and select the desired one from the list.
For detailed information about correct geographic values of your location, visit
websites such as dishpointer.com, itouchmap.com, or other reliable sources such as
professional journals.
Here you will nd a list of satellites, only select a satellite/s which is available in your
installation or have been con gured previously.
If this option is marked, the name and position can be changed using the RED
Rename Satellite button. To do this use pq and tu, on the shown keyboard, to
navigate.
Use the tu buttons to switch between the transponders of the selected satellite.
You can also press OK to list them. Use pq or P+/P- to scroll through the list.
Con rm your selection with OK. Press the RED button to Edit TP, the GREEN to Add TP
or YELLOW to Delete Current TP. Details can be found in chapter 7.1.3.1 Edit, add or
delete transponders
Use tu to select the channels you'd like to search for: All, only Free-to-air or
Encrypted channels.
TV & Radio searches for TV and radio channels, TV only for TV channels and radio only
for radio channels.
Use tu to select the search type to be performed. You can choose between the
following options:
Searching on the selected satellite.
Search for all installed satellites. * This option displays a menu for selecting the
installed satellites. After selection, please use the RED Search key to continue the
search.
NIT Scan on the selected satellite.
With this option you can install the simpliTV list at a later stage. In this case, previously
installed or available channels are kept and will be integrated in the simpliTV list. TV
or radio channels which are not included in the simpliTV list are listed starting with
18
Advertisement
Table of Contents
