1. Manuals
  2. Brands
  3. Strong Manuals
  4. Receiver
  5. SRT 7500
  6. User manual

Strong SRT 7500 User Manual

Digital high definition satellite receiver
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Digital High Definition
Satellite Receiver SRT 7500
User Manual

Advertisement

Table of Contents
loading

Related Manuals for Strong SRT 7500

Summary of Contents for Strong SRT 7500

  • Page 1 Digital High Definition Satellite Receiver SRT 7500 User Manual...

  • Page 4: Table Of Contents

    A.1 TRoUblESHooTInG A.2 SPECIfICATIonS APPEnDIX: InSTAllATIon ASSISTAnCE STRONG declares that this item complies with the basic requirements and other relevant regulations of directives CE 2004/108/EEC and 73/23EEC RoHS 2002/95EEC Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change.

  • Page 5: Introduction

    Attachments - For your safety, and to avoid damaging the product, use only accessories recommended by STRONG. Water and Moisture - Never use this product around water (near a bathtub, kitchen sink, laundry tub, wet basement.

  • Page 6: Storage

    PART 2 • English Apparatus - shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. Where the mains plug or all-pole mains switch is used as the disconnect device, the disconnect device shall remain readily operable.

  • Page 7: Your Receiver

    PART 2 • English Accessories: 1 x Remote control 2 x AAA Batteries 1 x HDMI cable 2.0 YoUR RECEIVER 2.1 front Panel Fig. 1 1. STAnDbY/on: Set receiver to Standby or ON mode. 2. MEnU: Access to the Main menu 3.

  • Page 8: Default Pin-Code: 0000

    Ensure that your satellite receiver is correctly connected to your TV and dish and your satellite signal is of good quality. Ask your local STRONG dealer to check your installation or satellite signal if you are not sure how to do this. Make sure that the power plug of receiver is plugged into the wall outlet.

  • Page 9: Country Selection

    PART 2 • English 4.2 Country Selection Select the desired country by using and press oK to continue. 4.3 Antenna Installation In the Antenna Installation Menu the necessary settings for the dish installation will be displayed. Depending on the selected country there might have been already done a setup for your satellite dish (Austria and Germany: Astra 19.2E on DiSEqC input 1/ Czech and Slovakia: Astra 23.5E on DiSEqC input 1).

  • Page 10: Favourites

    PART 2 • English symbol next the channel name. After you have marked all channels for locking, your changes will be saved by pressing bACK. Now you will have to enter your PIN every time you are switching to a locked channel. If you are not entering the PIN, the receiver will show after a few seconds the picture of the last watched channel until you enter the correct PIN.
  • Page 11 PART 2 • English positions and align your dish until signal strength and quality range are satisfying again and store this position. Now if you setup this specific SAT position correctly, you can apply realignment on the others by pressing oK at recalculate positions. note in order to avoid mechanical damage of your dish, please make sure the east and west limits in your motor are set correctly and dish would not hit any objects on its movement.

  • Page 12: First Time Installation

    PART 2 • English 5.3.2 fIRST TIME InSTAllATIon In this menu you have the possibility to do First Time Installation, which clears all stored channels in the channel list and all settings in your setup. Then a warning message will be displayed. There select YES if you want to delete or NO to cancel.

  • Page 13: Configuration

    PART 2 • English 5.4 Configuration In this menu you can set up your personal preferences for below adjustments. Use the for navigation and buttons to change settings. For entering values use the nUMERIC buttons. With bACK you can always cancel actions and exit the actual menu or submenu.

  • Page 14: Media Browser

    PART 2 • English SOKOBAN: to move the little girl and boxes. Press the RED button to cancel the last move. With blUE button you can restart the game. 5.7 Media browser Use this menu to play MP3 and JPEG files from a USB Memory device like memory stick, digital camera or multiple card reader etc.

  • Page 15: Zapping And Info Banner

    PART 2 • English Press GUIDE button in viewing mode to access the EPG Menu. The screen is divided into 3 main parts: at the left side the channel list is shown, at the right the program schedule list and in the upper part a short program description with program start/end time of the current channel.

  • Page 16: Troubleshooting

    PART 2 • English 6.3.2 Audio Mode and language Press A.foRMAT button in viewing mode. Further pressing will change audio channel between Left, Right and Stereo. Press the LANG button to select one of the available audio languages. 6.3.3 Video format Press the V.foRMAT button in viewing mode.

  • Page 17: Specifications

    PART 2 • English A.2 SPECIfICATIonS Demodulator Demodulation: QPSK, 8PSK Input symbol rate: DVB-S QPSK: 1 ~ 45 Ms/s DVB-S2 8PSK/QPSK: 10~30 Ms/s FEC decoder: Auto, 1/2, 2/3, 3/4, 5/6, 7/8 in DVB-S mode Auto, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 in DVB-S2 mode Auto, 3/5, 2/3, 3/4, 5/6, 8/9, 9/10 in 8PSK mode Video Decoder Profile level: MPEG-2 MP@ML, MP@HL, MPEG-4 H.264/AVC...

  • Page 18: Appendix: Installation Assistance

    APPEnDIX APPEnDIX: InSTAllATIon ASSISTAnCE...
  • Page 19 APPEnDIX...
  • Page 20 APPEnDIX...

Table of Contents