Table of Contents
Advertisement
7.1.1 Antenna Setup
In this menu, you can change and adapt settings for the antenna(s) and their transponders. Use the tu
buttons to change settings, and use pq to select an item, or press OK to list the settings. For the default
setting of DiSEqC 1.0, you can set the parameters for up to 4 satellite positions Port 1-4.
Satellite
LNB Power
LNB Type
LNB Freq
22 KHz Tone
DiSEqC 1.0
DiSEqC 1.1
Transponder
If Transponder is highlighted, the channel search can be started on this TP by using the RED Search button
or just press OK, the GREEN Auto DiSEqC Search* button allows you to search for available satellites in the
existing antenna installation.
*This function can nd available satellites within the already persisting installation. The precon gured satellites are: Astra 19.2E, Astra 23.5E, Astra 28.2E, HotBird
13.0E and Eutelsat 9.0E.
7.1.2 Motor Setting
If you are using DiSEqC 1.2 or USALS, you can install satellites which are received by a motorised dish. For the
correct installation and positioning of your motor, we recommend the support/advice of a professional and
experienced installer. Here you can con gure the motor type and set the motor position for a satellite that
you want to receive.
Satellite
Transponder
DiSEqC Motor
DiSEqC 1.2 selection
Move step-wise
Move continuously
Limit
Save to this position
Press OK to open the list of available satellites. Select the desired satellite with
pq or P+/P- and con rm with OK.
If necessary, you can change the LNB voltage using the tu buttons.
Select the desired LNB type using the tu buttons if you are not using a universal
LNB. Available are: C Band and User de ned.
Displays the corresponding values for the LNB type. 4 adjustments are possible.
Not con gurable at Universal LNB Type.
If DiSEqC 1.0 is used, up to 4 positions can be linked to satellites.
If DiSEqC 1.1 is used, up to 16 positions can be linked to satellites.
Press OK to open the list of available transponders for the selected satellite to
check the reception or select for channel search on it.
Press OK to open the list of available satellites and select one by using the pq or
P+/P- buttons, then press OK again for con rmation.
Press OK to open the list of available transponders if you like to set a speci c
transponder for the selected satellite.
Choose between DiSEqC 1.2 and USALS or O . Per default it is O because of pre-
de ned setup for DiSEqC 1.0.
Press tu to move your antenna east or west. Move carefully until you see
that both signal beams have an acceptable reception level. When you nd the
selected satellite, press and select Yes to save the position.
Use this function to move quickly to a desired position by holding down the t or
u key, depending on the direction in which you want to move the antenna. Also,
be very careful with it, so you do not bump into obstacles.
Press OK to open this sub-menu, which allows you to set the mechanical limits for
your motor. This is only necessary if your antenna is mounted which means, that a
wall, a tree or similar physical blockages could interfere with a free movement of
the antenna or motor.
You can store this position between 0 and 63, OK can be used again as described
above.
17
Advertisement
Table of Contents
