Table of Contents
Advertisement
Refer to the user manual of your TV and your antenna.
„
„
Make sure that the SCART/HDMI cable and outdoor components are in a good condition and
„
„
the SCART/HDMI connections are well shielded and from good quality.
This user manual offers complete instructions for installing and using this receiver. The following
symbols will serve as follows.
Warning
Indicates warning information.
Note
Indicates any other additional important or helpful information.
MENU
Represents a button on the remote control or the receiver.
(Bold characters)
Move to
Represents a menu item within a screen.
(Italic characters
1.4 Accessories
1x Installation instructions
„
„
1x remote control unit
„
„
2x batteries (AAA type)
„
„
1x adapter12 Volt DC, 1,5 Ampère
„
„
1.5 Usage of external USB devices
It is recommended to use USB 2.0 or higher storage devices. If your device is not compatible
„
„
to USB 2.0 specifications, recording, Time shift and playback with your receiver might not
work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be
„
„
the case that the power specifications exceed the supported output of your receiver (5 V/1 A).
If so, please connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„
„
It is advised not to store important information on USB storage devices used with the receiver. Always
make backups of data on your USB storage device before using it with this receiver. STRONG will not take
responsibility for any loss of information or circumstances caused by loss of information.
Please ensure that either the USB device is already formatted to FAT32, or format the USB
„
„
device via your receiver, refer to chapter 6.8 Recording.
STRONG cannot guarantee the playback of all files although extensions are listed, as it
„
„
depends on file size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
1. Standby/ON button
2. P-/P+
3. Indicator LED
4. USB
4
Switches the receiver ON or into Standby
Changes to the next/previous channel
GREEN indicates that the receiver is receiving signal, RED indicates that the
receiver is currently in standby mode.
To connect your USB storage device
Fig. 1
Advertisement
Table of Contents
