Table of Contents
Advertisement
NOTE:
5 min after switching the receiver into Standby it will enter the deep sleep mode. Within this
time the receiver is able to start up quickly. Starting up from deep sleep takes approx. 35
seconds.
6. OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This chapter describes
these features. Please also read chapter 7.0 to get familiar with the menu of your new receiver.
6.1 Changing channels
Your new receiver is equipped with three ways to change channels.
1. Via direct access
2. Via the channel list
3. Via the CH+/CH- or pq buttons
4. Via using the 9 button
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits is
possible. After entering the channel number just wait a few seconds or press OK and your receiver will
switch to the selected channel.
NOTE:
When using the simpliTV List some channel numbers may not be assigned or present in the list.
Channels which have been searched manually or been added personally (e.g. when you had
installed another list before installing the simpliTV List) will be assigned from channel number
400 onwards.
6.1.2 Channel list
Press OK in viewing mode to display the channel list. In the header section the corresponding name of the
selected channel list will be displayed. Use pq inside the channel list to highlight your channel of choice
and press OK to switch to the highlighted channel.
The channel list is equipped with a lter function to make it easier to nd your favourite channels. While in
the channel list, press RED. An alphabet banner will now be displayed. Use pq or P+/P- to select the rst
letter or number of the channel you wish to lter for and press OK or t to change to the ltered list. All
channels, beginning with the chosen letter, will now be listed at the left side (ascending order by channel
number). Then use the buttons as usually to select the desired channel. Afterwards the normal channel list
is displayed again. To quickly switch between your preferred channels, use the 9 button to display the list of
Recently watched channels.
The following buttons are available in the channel list and in viewing mode:
TV/R:
Toggles between TV and radio channels, in channel list changes the list mode.
LIST:
Opens the satellite list selection in viewing and list mode in case there is more than 1 satellite
installed.
FAV:
Displays the favourite list selection in both modes. Details about creating favourite lists can be
found in chapter 7.2.1 TV Channel Manager.
To return to the original respectively to the previous channel list /mode use TV/R or LIST.
6.1.3 Using the CH+/CH- buttons
CH+ or p will switch to a higher channel.
CH- or q will switch a lower channel.
14
Advertisement
Table of Contents
