Usage Of External Usb Devices; Your Receiver; Default Pin-Code: 0000; Front Panel - Strong 9120072370595 User Manual

WARNING:
NOTE:
Model: CH-AS120150E7xR; Manufacturer: Sichuan Changhong Electronic Component Co., Ltd.
„ „
Model: TB-AS120150E6xR; Manufacturer: Ten Pao Electronics (Huizhou) Co., Ltd.
„ „
Model: CY-AS120150E5xR; Manufacturer: Jiangsu Chenyang Electron Co., Ltd.
„ „
The usage of other power adapters may cause damage to the device. Such damage is not covered under
warranty.

1.5 Usage of external USB devices

It is recommended to use USB 2.0 or higher storage devices. If your device is not compatible to
„ „
USB 2.0 specifications, multimedia functions or software update might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the
„ „
case that the power specifications exceed the supported output of your receiver (5 V/500 mA). If
so, please connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„ „
It is advised not to store important information on USB storage devices used with the receiver.
„ „
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
For a proper performance with this receiver your USB device must be formatted to FAT32.
„ „
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends
„ „
on the used file size, codec, bit rate and resolution.

2.0 YOUR RECEIVER

2.1 DEFAULT PIN-CODE: 0000

2.2 Front Panel

1. IR Sensor
2. Indicator LED
3. STBY/ON
4. USB
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used, we recommend
using (e.g. NiMH) types with low self-discharge to ensure long time
operation of remote control.
For the appropriate usage with this device, use only power adapters as
listed below (in case of a necessary exchange):
Receives the RCU commands.
GREEN indicates that the receiver is currently ON, RED indicates that the
receiver is currently in Standby mode.
Switches the receiver ON or into Standby.
To connect your USB storage device for multimedia functions or software
update.
Fig. 1
5