Table of Contents
Advertisement
„ We as supplier cannot guarantee compatibility with all types of USB storage devices.
„ It is advised not to store important information on USB storage devices used with the receiver. Always
make backups of data on your USB storage device before using it with this receiver. We as supplier will
not take responsibility for any loss of information or circumstances caused by loss of information.
„ Please ensure that either the USB device is already formatted to FAT32
„ We as supplier cannot guarantee the playback of all les although extensions are listed, as it depends on
le size, codec, bit rate and resolution.
2. YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
1. LED Display
2. Standby indicator:
3. Power button
4. USB
2.3 Side Panel
1. Smart card slot
2.4 Rear Panel
1. SAT IN
2. HDMI
3. S/PDIF (coax.)
Displays channel number, time and status.
Shows power state of the receiver: Red LED - receiver is in standby mode
Switch the receiver to Standby or On
To connect your USB storage device
To insert your HD+ smart card with the golden chip facing down.
IN LIZENZ VON DOLBY LABORATORIES
GEFERTIGT. DOLBY, DOLBY AUDIO
UND DAS DOPPEL-D-SYMBOL SIND
EINGETRAGENE MARKEN
DER DOLBY LABORATORIES
LICENSING CORPORATION.
1
2
To connect to the LNB of your satellite antenna for reception of satellite
broadcast signal
To connect to the HDMI input of your TV set using a good quality HDMI cable
To connect to a digital ampli er or home theatre using a coaxial cable
1
2
3
1
3
4
6
4
5
Fig.1
Fig.2
Fig. 3
Advertisement
Table of Contents
