Your Receiver; Default Pin: 0000; Front Panel; Rear Panel - Strong SRT 8541FTA User Manual

2.0 YOUR RECEIVER

2.1 DEFAULT PIN: 0000

2.2 Front Panel

1. IR Sensor
2. LED Display
3. Mode Indicator LED
4. Standby/ON button
5. USB

2.3 Rear Panel

1. ANT IN
2. ETHERNET
3. S/PDIF Coaxial
4. HDMI
5. TV SCART
6. Power cord
7. Power switch

2.4 Remote control

1. q
2. !
3. 0~9
4. TV/R
5. 
6. FAV
7. 9
8. AUDIO
9.
10. EPG
11. pq
12. t u
Receives commands from the remote control
Shows channel number and time in standby
RED indicates that the receiver is in STANDBY mode.
Switches the receiver ON or into Standby
To connect your USB storage device.
To connect to your antenna for reception of broadcast signals.
To connect to your Ethernet cable (RJ-45) for RSS feeds and
weather forecasts
To connect your receiver to a digital home cinema set, AV
receiver or digital audio amplifier
To connect your receiver with your TV-set using an HDMI cable.
To connect your receiver with your TV-set using a SCART cable.
To connect to the main power (100 - 240 V AC ~ 50/60 Hz)
To switch the receiver on or off.
Switches the receiver On/Standby.
Mutes all audio outputs of the receiver
Enter channel number in TV mode or value input in menu
Toggles between TV or RADIO mode.
No function
Opens the favourite group selection.
One step back in menu or back to previous channel.
Opens the audio* language selection
Opens the current channel information; 2x opens the current
event information and 3x the next event information.*
Opens the EPG* (Electronic Programme Guide) in TV mode.
Change channel to next/previous.
Menu: Moves the cursor up/down.
Decreases/increases the volume level.
Menu: Change settings for specific menus.
Fig. 1
Fig. 2
Fig. 3
5