System Settings - Strong SRT 7511 User Manual

Subtitle language:
Volume settings:
NOTE: DVB subtitles on Astra 19.2 are currently available on di erent German channels: Das Erste
HD, ZDF HD, 3sat HD, arteHD, WDR HD and other popular channels. If you switch the Subtitles
Display to On, the according subtitles will be displayed automatically in case of availability
for this channel/movie. When the setting is O , subtitles can be temporary opened. Further
information about subtitles can be found on the broadcaster's own videotext pages or
websites.

7.3.2 System Settings

In this menu, you can adjust the video parameters according to the connected TV, while general settings are
also available.
HDMI Resolution:
Aspect Ratio:
Aspect Conversion:
HDMI Audio Output:
S/PDIF Audio Output: Here you can set the digital audio output via the coaxial S / PDIF. Press the tu
OSD Transparency:
Banner Time Out:
Recent channel list
Deep Standby After:
Please note that some events are broadcastwd with xed subtitles ( xed in the video
signal integrated). These subtitles can not be swtiched o .
Set the language for the subtitles, if available, subtitles are displayed in the selected
language.
Here, you can set whether channels should use a unite volume control or if this
should be controlled seperately Per Service. Try to nd out which setting works best
for you.
This allows you to set the resolution for your HDMI output. If your TV does not
support the newly set value, the screen turns black. In this case, wait for about 10
seconds and do not press any buttons on the remote control, then the value will
automatically be reset to the previous one.
Set the screen format that corresponds to that of the connected TV (4: 3 or 16: 9).
Set the image conversion as required.
When a TV is connected with the aspect ratio of 4: 3, the optimal mode is Letterbox.
A video in the 4: 3 format is not adjusted in this mode, but a video in the 16: 9 format
is adjusted so that it is reproduced completely and without distortion (there are black
horizontal bars above and below the picture). When a TV with aspect ratio 16: 9 is
connected, the optimum mode is 16: 9. A video in the 4: 3 format is reproduced with
this setting without distortion (however, there are black vertical bars on the left and
right of playback). A video in the 16: 9 format is displayed without image adjustment
and covers the entire screen. Note that it is also possible to set the format via the
menu of your TV (depending on your TV model).
Here you can set the setting for the digital audio output via HDMI. Press the tu
buttons to select between BitStream and PCM. If a TV set that supports Dolby® Digital
* is connected, use the BitStream setting. If this is not the case, use PCM.
buttons to select between BitStream and PCM. If a home theater, ampli er, or similar
is connected that supports Dolby® Digital *, use the BitStream setting. If this is not the
case, use PCM.
You can set the transparency in this menu. You can choose between di erent values
and Cover
Here you can adjust how long the infobanner is displayed.
Here, you can change the function of the 9 button, by default set On, which allows
you to open the Recently watched channels list using 9 in TV mode to access up to
30 of the most recently watched channels. If you set O , the button will only change
between the 2 last watched channels.
This function switches the receiver into a power-saving mode (Deep Sleep) after
switching it o (into standby) within the set time. Available settings are: 5 minutes, 15
22