Table of Contents
Advertisement
WARNING:
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„
„
specifications, the playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
„
„
specifications might exceed the supported output of your receiver (5 V/500 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„
„
It is advised not to store important information on USB storage devices used with the receiver.
„
„
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss of
information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB
„
„
device via your receiver. Formatting requires entering the PIN code
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on
„
„
file size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 PIN-CODE
The PIN code is set by the user during the installation wizard. To modify the code, go to the System
menu, Set Password. See also chapter 4.
2.2 Front Panel
1. Power button:
2. P-/P+:
3. LED Display
4. Mode indicator:
5. IR sensor:
6. USB:
2.3 Rear Panel
1. ANT IN
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used, we recommend
using (e.g. NiMH) types with low self-discharge to ensure long time
operation of remote control.
Switch the receiver to Standby or On.
To change channels without using the remote control
Shows channel number and time in standby
RED indicates that the receiver is in STAND-BY mode.
GREEN indicates that the receiver is in OPERATING mode.
Point your remote control towards this sensor.
Connector for USB devices.
To connect to your antenna for the reception of terrestrial
broadcast signal.
Fig. 1
Fig. 2
5
Advertisement
Table of Contents
