Starting Up For The First Time; Language And Video Settings; Antenna Setup - Strong SRT 7511 User Manual

Connecting to a Digital Audio Ampli er with S/PDIF
By connecting your receiver to a digital ampli er or home theatre system, you can enjoy the best possible
sound quality and multi-channel audio (depending on broadcast). Connect your Digital Audio Ampli er or
home theatre system with a suitable cinch cable to the S/PDIF connector on the back of the receiver
Connecting to a digital audio ampli er and TV using HDMI
If you want to connect your home theater, ampli er or AV receiver using HDMI, connect one end of a high-
quality HDMI cable to the HDMI connector on your receiver and the other end to the HDMI input on your
digital audio device.
The HDMI output of the digital audio device is then connected to the TV with another high-quality HDMI
cable. Select the appropriate input on your digital audio device as well as on the TV to use high quality
audio and video signals.

4. STARTING UP FOR THE FIRST TIME

Ensure that your satellite signal is of good quality and that all connections are properly setup. In case of
di culties or questions, please ask your local dealer or service hotline for assistance. It is recommended to
follow the First Time Installation gradually. It will guide you through the basic installation and setup process.
You can enjoy digital HD broadcasts within just a few minutes. To enjoy the complete range of channels
and to watch your preferred scrambled services, please register with the enclosed registration form at ORF-
DIGITAL-DIREKT.
If you have further questions about your registration, you can directly contact the ORF-DIGITAL-Service-
Hotline (0800 700 600). Please have your Device-ID (Gerätenummer) ready.

4.1 Language and Video Settings

After connecting your receiver for the rst time, the OSD Language, Aspect Ratio, Aspect Conversion and
HDMI Resolution menus will be shown. Change your language with tu and use pq to select the other
settings. For these settings, you can also use OK to show a list of available settings. Adjust the Aspect Ratio
according to your TV (4:3 for an analogue CTV set and 16:9 for your new at screen / HD TV) and select the
Conversion of your preference.
For HDMI Resolution the default setting 720p is recommended, but many TVs already support higher
resolutions. Therefore, you can choose 1080p.
NOTE: If you select an HDMI resolution which is not supported by your TV, the receiver will switch to
the previous setting automatically after ~10 sec. If you can see the displayed message, please
con rm the selected resolution by pressing OK.
During any stage of the First Time Installation, you can press BLUE Next to go to the next step or YELLOW
Previous to get back to the previous step.

4.2 Antenna Setup

This receiver is already adjusted for reception of Astra 19.2 satellite with the correct settings. Per default it
is setup for DiSEqC port 1, but you can use the setting as well if you are not connected to any switch. You
only need to change these settings if you are not connected to Astra 19.2 or this satellite is not connected to
port 1 of your DiSEqC switch. To adjust your antenna settings for the Satellite, LNB Power, LNB Type, LNB Freq,
DiSEqC 1.0 and Transponder correctly, use the tu and pq buttons.
For user convenience which have a multi dish installation, the Auto DiSEqC Scan* function is supported,
which can be activated by pressing the GREEN button.
For further details and information about the settings, see chapter 7.1.1 Antenna Setup.
In the First Time Installation, it is possible to adjust the settings for up to 4 satellite positions. To proceed
within the First Time Installation, use the BLUE Next button to follow the steps.
12