Transmitting An Image; Sending An Image In Scan Mode - Sharp MX-M753 Operation Manual

TRANSMITTING AN IMAGE

SENDING AN IMAGE IN SCAN MODE

This section explains the basic procedure for transmission in scan mode (Scan to E-mail, Scan to FTP, Scan to
Desktop, and Scan to Network Folder).
When a default address is configured in "Default Address Setting" in the system settings (administrator), the mode cannot be
changed, the destination cannot be changed, and destinations cannot be added. If you wish to change the mode or
destination, touch the [Cancel] key in the touch panel and then follow the procedure below.
When "Default Address Setting" is set to "Apply E-mail address of the user for login.", pressing the [Add Address] key on the
touch panel switches modes and adds addresses.
• When placing the originals, orient them as shown below.
Originals
Portrait orientation*
1
1
Landscape orientation
1
* To place a large portrait-oriented original, place it as shown above in "Landscape orientation" and specify the
placement orientation in step 3.
• Place 5-1/2" x 8-1/2" (A5) size originals in portrait (vertical) orientation (
orientation (
manually.
• Originals cannot be scanned in succession from both the automatic document feeder and the document glass and
sent in a single transmission.
Original size
detector
Document feeder tray
Place the original face up.
), an incorrect size will be detected. For a 5-1/2" x 8-1/2"R (A5R) size original, enter the original size
Place the original.
Do not place any objects under the original size detector.
Closing the automatic document feeder with an object
underneath may damage the original size detector plate and
prevent correct detection of the document size.
Place the original face down and align the
corner with the tip of the arrow mark
top left corner of the document glass scale.
1
1
5-28
SCANNER/INTERNET FAX
Document glass
1
1
). If placed in landscape (horizontal)
Contents
in the