Manual Operation Of The Inserter - Sharp MX-M753 Operation Manual

MANUAL OPERATION OF THE INSERTER

The inserter can be used for stapling or punching without performing a copy operation. These functions are selected at
the operation panel of the inserter.
(1) [PUNCH] key
When a punch module is installed on the finisher or
saddle stitch finisher, punch holes can be added to blank
paper or printed paper. The indicator lights when this
function is selected.
(2) [STAPLE] key/indicator
When this function is selected, each set of output is
stapled and delivered to the finisher or saddle stitch
finisher tray. (Note that the sets are not offset.) Press this
key until the icon light of the desired staple position lights
up. (" " pamphlet stapling can only be selected when a
saddle stitch finisher is installed)
• Do not use tabbed paper when operating the inserter manually.
• The punching and stapling functions cannot be used when the finisher or saddle stitch finisher has failed, or when the
functions are prohibited* in the administrator settings (7. SYSTEM SETTINGS
* Disabling of stapler/Disabling of punch/Disabling of finisher/Disabling of inserter
(1) (2)
1-63
BEFORE USING THE MACHINE
(3)
(3) [START] key/indicator
After selecting punch or staple settings with key (1) or
key (2), place the paper to be punched or stapled on the
inserter tray and press this key.
"Enable/Disable Settings" (page 7-45)).
Contents