Sharp MX-M753 Operation Manual page 175

3
• Up to 999 copies (sets) can be set.
• A single copy can be made even if "0" appears for the number of copies.
If an incorrect number of copies is set...
Press the [CLEAR] key (
Press the [START] key.
Normally copying will start.
4
Depending on the copy settings (2-sided copying, etc.), copying may not begin until all originals have been scanned. In this
case, go to the next step.
Remove the original and place the next original, and then press the [START] key.
5
Repeat this step until all originals have been scanned.
Place next original. Press [Start].
When finished, press [Read-End].
6
To cancel scanning of the original and copying...
Press the [STOP] key (
7
Special Modes
2-Sided Copy
Plain
8½ 11
) and then enter the correct number.
Read-End
).
Set the number of copies (number of
sets) with the numeric keys.
Touch the [Read-End] key.
2-15
COPIER
Contents