Sharp MX-M753 Operation Manual page 848

Problem
Printing does not take
place.
Two-sided printing
does not take place.
Direct printing of a file
in a shared folder on a
computer is not
possible.
A tray, finisher, or
other peripheral
device installed on the
machine cannot be
used.
Point to check
Was a Notice Page printed?
Have functions been disabled by the
administrator?
Does the paper type setting of the
selected tray specify a type of paper that
cannot be used for two-sided printing?
Are you using a special size or type of
paper?
Have functions been disabled by the
administrator?
Is "IPsec Settings" enabled on the
machine?
Have the peripheral devices that are
installed on the machine been
configured in the printer driver?
Check the printed Notice Page.
A Notice Page will be printed to indicate the cause of the
problem if a print job cannot be performed as specified
and the cause is not shown in the display. Read the
printed page and take appropriate action.
For example, a notice page will be printed in the
following situations.
• The print job is too large to fit in memory.
• A function that has been prohibited by the
administrator is specified.
By factory default, Notice Pages are not printed.
Check with your administrator.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check "Tray Settings" in the system settings.
If the [Disable Duplex] checkbox is selected
two-sided printing using that tray will not be possible.
Change the paper type setting to a type that can be
used for two-sided printing.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change"
For the paper types and sizes that can be used for
two-sided printing, see "SPECIFICATIONS" in the
Start Guide.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check with your administrator.
When "IPsec Settings" is enabled in the system settings
(administrator), direct printing of a file in a shared folder
may not be possible in some computer environments.
➞ System Settings (Administrator) > "Security Settings"
> "IPsec Settings"
Open the printer properties and click the [Auto
Configuration] button on the [Configuration] tab.
(Windows)
If auto configuration cannot be executed, see
1. BEFORE USING THE MACHINE
SETUP"
8-29
TROUBLESHOOTING
Solution
,
"SOFTWARE
Contents